Charging

Warning

Ensure that the robot is turned off before charging.

Warning

Connect the cable of the charger to the robot before connecting the charger to the power source.

Note

For more information about the charging process, see the Husarion Rosbot XL Documentation at Husarion Rosbot 2 PRO.

To charge the robot, follow these steps:

  1. Connect the power adapter to the charger and the output cable between charger and ROSbot (2 connectors on charger side, 1 black connector to ROSbot charging port).

  2. Use red and blue buttons to select LiPo BATT mode and press [Start].

  3. Use arrows to select LiPo CHARGE mode.

  4. Press Start - the current value should start blinking. Use arrows to set the current to 1.5A.

  5. Press Start again - the voltage value should start blinking. Select 11.1V(3S) using arrows. The picture below shows the desired result.

  6. Press and hold Start for 2 seconds. The charger should now ask for confirmation. Press Start again. The charging process should begin now.

  7. When the charging will be finished (after about 3 hours), the charger will generate a loud beep sound and will finish charging at the same time.